attoPUBLICATIONS attoCATALOG-2015/16 | Page 132

attoAFM /STM PAGE 130 Specifications attoAFM/STM General Specifications type of instrument tuning-fork based AFM with wire-type tip, capable of non-contact mode AFM and STM sensor head specifics etched metal wires, e.g. Pt/Ir or Tungsten wire (also compatible with NaugaNeedles commercial tips) Operation Modes imaging modes non-contact mode AFM, EFM, SGM, STM, STS slope compensation 2 axis scan plane correction z feedback AFM: PI feedback loop for amplitude modulation (AM), phase modulation (PM) or frequency modulation (FM) using included PLL STM: constant current, cons Resolution* measured z-noise density < 16 pm/√Hz tunneling current noise < 40 fA/√Hz @ 7 kHz bandwidth (out of contact) z bit resolution @ 4 K 7.6 pm at 2 μm scan range Sample Positioning total travel range 5 x 5 x 5 mm³ (open loop) step size 0.05..3 μm @ 300 K, 10..500 nm @ 4 K fine scan range 40 x 40 x 4.2 μm³ @ 300 K 9 x 9 x 2 μm³ @ 4 K sample holder ASH/QE/4CX quick-exchange sample holder with 8 electrical contacts, integrated heater calibrated temperature sensor Suitable Operating Conditions temperature range 1.5 K..300 K (dependent on cryostat); mK compatible setup available on request magnetic field range 0..15 T+ (dependent on magnet) operating pressure designed for He exchange gas (vacuum compatible version down to 1E-6 mbar on request) Suitable Cooling Systems titanium housing diameter 48 mm bore size requirement designed for a 2" (50.8 mm) cryostat/magnet bore compatible cryostats attoLIQUID1000/2000/3000/5000 Electronics scan controller and software ASC500 (for detailed specifications please see attoCONTROL section) Options closed loop upgrade for coarse positioners resistive encoder, range 5 mm, sensor resolution approx. 200 nm, repeatability 1-2 μm in-situ inspection optics tip/sample monitoring via in-situ LT-LED for illumination, mirrors, lenses and CCD camera (outside of cryostat) field of view approx. 3 mm x 2 mm, res closed loop scanning upgrade interferometric encoders available * Resolution may vary depending on applied tip, sample, and cryostat The attoAFM /STM microscope stick